The I/O module I/O-04B-230V-12A can be used to switch 4 circuits with a maximum of 230V/12A. The phase position of the individual fuses is arbitrary. 4 optocoupler inputs 12-48V on a common counter potential are available as inputs. The functions of all inputs and outputs can be freely programmed via the software.
From production 2015, the modules will be available with the following parameterizable functions:
| Operating voltage | 16V to 35V DC resp. 16V to 27V AC |
| Current consumption |
16V DC = 230mA, 24V DC = 150mA, 35V DC = 110mA 16V AC = 220mA, 24V AC = 140mA, 27V AC = 120mA (all relays energized) |
| Inputs | 4x 12-48V AC/DC, input current per input 5mA at 24V |
| Outputs |
4x relay contact 250V AC (DC max. 25V!) Load capacity: pure ohm's 12A bulbs 10A fluorescent lamps uncompensated 6A fluorescent lamps compensated 4A low voltage halogen via transformer 10A phase motor 0.55kW ECGs depending on manufacturer, inrush current 100A < 20ms ! The inrush current of electronic ballasts is up to 100 times the rated current !! Minimum contact load: 500mW, min. 10V, min. 5mA |
| Subnet (RS-485) | max. 5.6V limitation by Z-diodes |
| Connection | screw terminals 2.5mm², inputs and BUS pluggable, BUS connector |
| Operating temperature | -10...+50°C |
| Storage temperature | -25...+70°C |
| Humidity | 0...85 % r.h. non-condensing |
| Protection class | in non-installed condition IP30 |
8-pole DIP switch for setting the ISYGLT BUS address (0-127) is located under the cover of the module.
| LED | Designation | State | Meaning |
|---|---|---|---|
| red | POWER | Off | No operating voltage |
| On | Operating voltage, no error | ||
| yellow | BUS | Off / On | Error BUS |
| blinking | Interference-free data transmission via the BUS line | ||
| 4x green | A1-A4 | Off | Output inactive |
| On | Output active |
The ISYGLT ProgramDesigner offers a wide range of parameterisation options:
Article no.: 80022004
