
WATCH-DOG-02
Article no.: 80083101
-
kostenlose Anfrage / free request
from 1 € 0.00 € 0.00
The WATCH-DOG Module is used to monitor the ISYGLT subnet. An application case is switching to an emergency operating level when errors are detected in the BUS or the Power Supply. Short-circuits and interruptions of the BUS line or a failed Master Module can be detected with the module. This module can be used to switch redundant BUS segments to a second Master Module, for example, or to control corresponding emergency operation relays in sub-distribution boxes in the event of failure/emergency. The time until the output is activated when an error is detected can be adjusted via parameter setting. A test function is also available in BUS operation.
Operating voltage | 16-35V DC or 16-27V AC |
Current consumption | 24V DC = 85mA |
Inputs | 12-48V AC/DC, input current per input 5mA at 24V |
Output |
relay contact 250V AC (DC max. 25V); load capacity: pure ohm's 10A bulbs 10A fluorescent lamps uncompensated 6A fluorescent lamps compensated 4A low voltage halogen via transformer 10A 1-phase motor 0.55kW ECGs manufacturer dependent, inrush current 100A < 20ms ! The inrush current of electronic ballasts is up to 100 times the rated current! Minimum contact load: 500mW, min. 10V, min. 5mA |
Subnet (RS-485) | max. 5.6V limitation by Z-diodes |
Connection | screw terminals 2.5mm², pluggable, BUS connector |
Operating temperature | -10...+50°C |
Storage temperature | -25...+70°C |
Humidity | 0...85 % r.h. non-condensing |
Protection class | in non-installed state IP30 |
8-pole DIP switch for setting the ISYGLT BUS address (0-127) is located under the cover of the module.
DIP-1 | Setting |
---|---|
OFF | BUS operation |
ON | No function, but adjustable by parameter |
LED | Designation | State | Meaning |
---|---|---|---|
red | Power | Off | No operating voltage |
On | Operating voltage, no error | ||
yellow | BUS | Off / On | Error BUS |
blinking | Interference-free data transmission via the BUS line | ||
4x green | BUS failure | blinking | LEDs signal a BUS failure by chaser animation, LED 1 is on during BUS operation |
In the ISYGLT ProgramDesigner there are various parameterisation possibilities:
=Ub | Operating voltage |
0V | 0V Operating voltage |
A | BUS A (subnet RS-485) |
B | BUS B (subnet RS-485) |
CE | Common potential for E1-E4 (e.g. 0V) |
E1 | Input 1 |
E2 | Input 2 |
E3 | Input 3 |
E4 | Input 4 |
Article no.: 80083101