ISYwireless is the perfect completion to the proven ISYGLT for bridging distances where no BUS cable is possible.
DALI components and EnOcean devices from a wide range of manufacturers can be easily linked via the ISYGLT BUS System and fully integrated into the system. This also makes wireless control of ISYGLT dimming actuators very easy.
The "green" EnOcean radio technology based on 868 MHz radio is used. This is characterised as particularly failure-free and energy-saving. The ranges of approx. 30m are absolutely sufficient for most applications. Otherwise, the gateways also work as repeaters in mesh technology. Due to the low energy consumption and the transmission of protocols only when really necessary, the technology can be described as absolutely "green" in terms of saving resources, health and interference emission.
GW-EnOcean-08EnOcean Gateway for wireless connection of sensors and actuators, such as additional pushbuttons, temperature sensors or motion sensors to the ISYGLT BUS technology.
EnOcean-ISYGLT-01The Sensor/Actuator Module is used for wireless radio connection of ISYGLT modules to EnOcean technology. Up to 8 of these Sensor/Actuator Modules can be managed and controlled by one GW-EnOcean-08 Gateway.
EnOcean-DALI-01The Actuator Module is used for wireless control of DALI lights with the ISYGLT system. DALI control types such as DT6 and DT8 broadcast and group control, HCL, RGB, RGBW and Tunable White are possible.
With the EnOcean Gateway a large number of standard EnOcean components from different manufacturers can be integrated into the ISYGLT System. These components can be used without compromise through the free ISYGLT programming for intelligent building automation.
interoperable products from a wide range of suppliers in accordance with international standards
Setup of the ISYwireless Solutions
The system always consists of one or more base stations on the ISYGLT Subnet BUS (master module) and one or more participants that output ISYGLT or DALI or are direct EnOcean sensors or actuators.
There are 2 variants available:
ISYGLT GW-EnOcean-08: Works with the standard EnOcean protocol and can communicate with ISYGLT gateways and EnOcean components.
ISYGLT GW-ISYwireless-20: This is a proprietary protocol based on EnOcean. It was developed for special applications such as façade control. Only ISYwireless-DALI-01 and ISYwireless-ISYGLT-01 can be integrated with it.
the client devices represent the opposite side of the base station. These are e.g. gateways EnOcean to DALI or the EnOcean components themselves.
Each base station or client device (except some EnOcean actuators and sensors) can be used as a repeater. This allows a mesh network to be set up and communication to be ensured even under difficult conditions.
Of course a good selection of EnOcean components from other manufacturers can also be integrated into the GW-EnOcean-08. Up to 30 actuators/sensors are possible per gateway.
Guide for technicians as PDF for download:
A lot of important information for planning, programming and commissioning of ISYwireless gateways and EnOcean components.